Component Tools
-
Professional quality, precision-sized spoke wrenches are hardened and nickel plated for long service. Park Tool Spoke Wrenches are vinyl coated in one of five colors indicating the size at a glance.
-
Professional quality, precision-sized spoke wrenches are hardened and nickel plated for long service. Park Tool Spoke Wrenches are vinyl coated in one of five colors indicating the size at a glance.
-
Professional quality, precision-sized spoke wrenches are hardened and nickel plated for long service. Park Tool Spoke Wrenches are vinyl coated in one of five colors indicating the size at a glance.
-
Unique four-sided design provides extra strength and support and helps prevent slipping and deformation of aluminum nipples. Uses the same world famous design and high quality materials as our three-sided spoke wrenches.
-
- Fits Atom®, Regina®, splined Zeus®, and some Schwinn®-approved freewheels
- The FR-4 has 20 splines and is approximately 21.6mm in diameter
- Center bore for axle clearance is 10mm
- Always use a skewer or axle nut to hold tool firmly in place during removal
-
- Base size for socket or wrench is 1" or 25.4mm
- Center bore for axle clearance is 15mm
- Always use a skewer or axle nut to hold tool firmly in place during removal
-
Park Tool Pin Spanners have been designed to give maximum usefulness and versatility at the lowest possible cost. Tough, high carbon tool steel is used on each tool to ensure long life. Handle is vinyl coated to give a good grip. Each Pin Spanner is color-coded for easy recognition.
-
- Manufacturer Part Number: FR-5.2
- UPC: 763477003485
-
- Fits adjusting cone on most gear clusters
- Color-coded red handle for easy identification
-
- Fits older Suntour® two-notch freewheels
- Two notches are approximately 25mm across measured outside to outside
- Center bore for axle clearance is 10mm
- Always use a skewer or axle nut to hold tool firmly in place during removal
-
The BBT-4 is compatible with the following sealed cartridge bottom brackets:
- Campagnolo®
- Veloce™
- Xenon™
- Mirage™
- Daytona™
- Avanti™
- Campagnolo®
-
This CNC machined, 4-in-1 spoke wrench and valve extender tool can restore a wheel knocked out of true, and change a valve extender during a flat repair.
-
NOTE: The MLP-1.2 does not work on traditional 2 and 3-piece master links (shown in the images) commonly found on single speed or 3-speed bicycles that use a single rear sprocket. These style of master links have the two pins attached on one side plate and use a side plate that clips on or a side plate and a spring clip to hold the opposite plate on. To remove this type of master link, use a needle nose pliers to slide the spring clip off, remove the outer plate and then remove the side with the two pins or remove the single side plate.
-
This small chain tool goes anywhere and actually performs like a shop quality tool. The fine thread, special V-shaped handle, and super strong replaceable pin make chain removal and installation a breeze.
-
- Specifically designed to remove crank arms from splined Shimano® Octalink® and ISIS Drive™ bottom bracket spindles that do not use a self-extracting system
- 22 x 1 mm fine thread provides leverage needed to remove tight crank arms
- Strong rotating tip system ensures smooth operation and long life