SRAM Disc Brake Hose Kit - Double Compression | 2000mm

What SRAM brakes use the Double Compression 2000mm hose kit?

The SRAM Disc Brake Hose Kit in Double Compression format is the correct replacement hose for SRAM hydraulic brakes that use compression fittings at both lever and caliper — as opposed to banjo-style caliper connections used in other SRAM brake families. The double compression system uses a compression fitting on each end of the hose rather than a banjo bolt, and those fittings are not interchangeable with banjo or Stealthamajig-style connections. Verify that both the lever-side and caliper-side of your specific brake use compression fittings before ordering. At 2000mm, the hose accommodates any standard bicycle routing geometry and is cut to length at installation. All fittings and hardware for a complete connection at both ends are included.

Hose replacement with the double compression system follows the same workflow as other SRAM hydraulic hose kits — cut to length, insert barbs, compress olives, and complete a full DOT fluid bleed. A dedicated hose cutter produces the clean square end necessary for proper olive compression and a reliable hydraulic seal; irregular cuts are the most common cause of post-installation sponginess that cannot be resolved with additional bleeding. This kit is compatible with both SRAM road and MTB hydraulic brakes that use the double compression fitting standard. Replace any time the hose shows kinking, cracking, or evidence of fluid seeping at a fitting — hydraulic fluid on the rotor or pads requires immediate attention before the next ride.